Hello XDA,
I did brick my phone by trying to downgrade to 5.0.2 from 5.1.1 and bricked my phone and searching this forum I felt that there should be a post like this to ease the journey of people like me. As I did learn a lot from my 5 years android journey, I would like help everybody like me. Therefore if I find any important/"you may not know" fixes, I will share here with headings. Also If you have another solutions for any problems of these kind; please write here so I can collect em' all in the OP. Let's go!
Solution: This is caused because of your partition(pit). In XDA, you can find .pit files of S6 Edge for several models (i.e. I have a g925f so i have to find the corresponding pit file. The one worked for me was the G925F pit with Hidden_300M. First you flash this pit to your phone, then try to flash your rom; you're good to go!
Solution: Please do the combo "Volume Down-Home-Power" until you reach download mode. When you reach there again do the same combo until the screen goes off. When it goes off QUICKLY switch to "Volume Up-Home-Power" combo and hold it until the screen comes in and dims a bit. When it dims release all buttons and ta-da you're in recovery mode.
Solution: This problem is caused because of the nand mismatches (generally, or build differences etc.). Solving this may cause a hard-brick IF YOU DON'T follow the instructions CAREFULLY.
1) Get your device to download mode by using this combo "VolumeDown-Home-Power"
2) Open an UP TO DATE ODIN.
3) Find the corresponding .PIT file for your S6 EDGE.
4) Find the corresponding stock rom for your S6 EDGE.
5) Then put them into odin CORRECTLY. Rom to "AP", .pit to PIT
6) Make Sure these are checked: "Re-partition","NAND all erase"
7) Plug your device in and then press start.
After these you should be already flashed correctly without any nand write fail.
I did brick my phone by trying to downgrade to 5.0.2 from 5.1.1 and bricked my phone and searching this forum I felt that there should be a post like this to ease the journey of people like me. As I did learn a lot from my 5 years android journey, I would like help everybody like me. Therefore if I find any important/"you may not know" fixes, I will share here with headings. Also If you have another solutions for any problems of these kind; please write here so I can collect em' all in the OP. Let's go!
-ODIN fail while flashing hidden.img-
Solution: This is caused because of your partition(pit). In XDA, you can find .pit files of S6 Edge for several models (i.e. I have a g925f so i have to find the corresponding pit file. The one worked for me was the G925F pit with Hidden_300M. First you flash this pit to your phone, then try to flash your rom; you're good to go!
---------------------------------------------------------------
-If you can't properly enter to recovery mode-
-If you can't properly enter to recovery mode-
Solution: Please do the combo "Volume Down-Home-Power" until you reach download mode. When you reach there again do the same combo until the screen goes off. When it goes off QUICKLY switch to "Volume Up-Home-Power" combo and hold it until the screen comes in and dims a bit. When it dims release all buttons and ta-da you're in recovery mode.
---------------------------------------------------------------
-ODIN gives a fail at NAND write-
-ODIN gives a fail at NAND write-
Solution: This problem is caused because of the nand mismatches (generally, or build differences etc.). Solving this may cause a hard-brick IF YOU DON'T follow the instructions CAREFULLY.
1) Get your device to download mode by using this combo "VolumeDown-Home-Power"
2) Open an UP TO DATE ODIN.
3) Find the corresponding .PIT file for your S6 EDGE.
4) Find the corresponding stock rom for your S6 EDGE.
5) Then put them into odin CORRECTLY. Rom to "AP", .pit to PIT
6) Make Sure these are checked: "Re-partition","NAND all erase"
7) Plug your device in and then press start.
After these you should be already flashed correctly without any nand write fail.
Aucun commentaire:
Enregistrer un commentaire